Insignia NS-TWM41WH8A User Manual - Page 18

INSTALLATION INSTRUCTIONS 4 Connect the ends of the water supply hoses to the water supply intake connections at the top of the washer. Make sure that the rubber washers are in place. The water supply hose connected to the hot faucet must be connected to the hot water supply intake and the water hose connected to the cold faucet must be connected to the cold water supply intake. Notes • If you do not want to use the hot water supply hose, insert a water intake cap into the hot water supply intake hole. In this case, you must select the Tap Cold option for the water temperature. • No intake cap is provided with your washer. It must be purchased separately. 5 Tighten the fittings by hand until they are snug, then tighten them an additional two-thirds of a turn with a wrench. Caution • Do not overtighten the fittings or apply tape or sealant to the faucets or water supply intakes. This can damage the fittings. • Make sure that the water supply hoses are not twisted or bent. A bent or twisted hose can leak and cause an electric shock due to the water leakage. To ensure the correct water usage, connect both hot and cold water faucets. If either or both are not connected, an error code could occur. 6 Turn on the hot and cold water supplies and check all the water supply intake connections and the faucets for water leaks. 18 www.insigniaproducts.com