Intel DQ965CO DQ965CO Technical Product Specification - Page 77
Overview of BIOS Features - cpu support
View all Intel DQ965CO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
3 Overview of BIOS Features What This Chapter Contains 3.1 Introduction 77 3.2 BIOS Flash Memory Organization 78 3.3 Resource Configuration 78 3.4 System Management BIOS (SMBIOS 79 3.5 Legacy USB Support 80 3.6 BIOS Updates 80 3.7 BIOS Recovery 81 3.8 Boot Options 82 3.9 Adjusting Boot Speed 83 3.10 BIOS Security Features 84 3.1 Introduction The board uses an Intel BIOS that is stored in the Serial Peripheral Interface Flash Memory (SPI Flash) and can be updated using a disk-based program. The SPI Flash contains the BIOS Setup program, POST, the PCI auto-configuration utility, and Plug and Play support. The BIOS displays a message during POST identifying the type of BIOS and a revision code. The initial production BIOSs are identified as CO96510J.86A. When the BIOS Setup configuration jumper is set to configure mode and the computer is powered-up, the BIOS compares the CPU version and the microcode version in the BIOS and reports if the two match. The BIOS Setup program can be used to view and change the BIOS settings for the computer. The BIOS Setup program is accessed by pressing the key after the Power-On Self-Test (POST) memory test begins and before the operating system boot begins. The menu bar is shown below. Maintenance Main Advanced Security Power Boot Exit NOTE The maintenance menu is displayed only when the board is in configure mode. Section 2.8 on page 67 shows how to put the board in configure mode. 77