Invacare CLTD Owners Manual - Page 54
Adjusting Trigger Release Cables, 14 to 20-Inch Wide Wheelchairs
View all Invacare CLTD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
SECTION 7-TILT 7. When the seat reaches the desired angle, slow let go of the trigger release levers. 8. To lower the seat parallel with the floor, reverse the above sections. Trigger Release Lever Back Cane FIGURE 7.1 Engaging Tilt-In-Space Adjusting Trigger Release Cables NOTE: For this procedure, refer to FIGURE 7.2 on page 56. 14 to 20-Inch Wide Wheelchairs ƽ WARNING DO NOT adjust the trigger release cables while the cables are coiled up. The adjustment will be too tight when the cable is straightened and the gas cylinder will not lock and hold its position, possibly causing injury. 1. To adjust the left gas cylinder, squeeze the trigger release lever of the right cable assembly and try to tilt the wheelchair. NOTE: The wheelchair should not tilt. 2. If the left side of the wheelchair tilts without squeezing the trigger release lever of the left cable assembly, perform the following steps: A. Loosen the cable locking nut that secures the cable adjusting nut in place. B. Turn cable adjusting nut one of two ways: NOTE: If the cable is too loose, the tilt mechanism will not work. ƽ WARNING DO NOT over tighten the cable adjusting nut on the cable. Over tightening the cable adjusting nut on the cable WILL unlock the tilt mechanism, possibly causing injury. Compass™SPT™ 54 Part No 1122134