Invacare SPT Owners Manual - Page 31

SECTION 4-FRONT RIGGINGS Installing/Removing Lift-Off Footrest NOTE: For this procedure, refer to FIGURE 4.2. Installing 1. Insert the footrest assembly mounting pins into the mounting tube of the wheelchair frame. 2. Repeat STEP 1 for the other footrest assembly. 3. If necessary, adjust the footrest height. Refer to Adjusting Footrest Height on page 31. Removing 1. Push the footrest release lever inward and lift footrest upward. 2. Repeat STEP 1 for opposite side, if necessary. Mounting Pin Footrest Release Lever Wheelchair Frame Mounting Tube Footrest Assembly Footplate FIGURE 4.2 Installing/Removing Lift-Off Footrest Adjusting Footrest Height Height Adjustment Ranges FOOTREST TYPE 60° 70° 90° 90° ADJUSTMENT RANGE 13-17 inches 13-17 inches 5-8 inches 5-11 inches (with 3-inch extension) 60°, 70° and 70° Taper NOTE: For this procedure, refer to FIGURE 4.3 on page 32. 1. Remove the footrest from the wheelchair. Refer to Installing/Removing Swingaway Front Riggings on page 30. 2. Remove the hex screw and coved spacer and slide the footrest up or down on its mounting tube until the desired footrest height is achieved. 3. Reassemble the hex screw and coved spacer through the footrest upper support and mounting tube (FIGURE 4.3). Part No 1122134 31 Compass™SPT™