Invacare SPT Owners Manual - Page 58
Replacing/Repairing Caster Tire/Tube, Installing/Removing Rear Wheels, Quick-Release
View all Invacare SPT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
SECTION 8-WHEELS Replacing/Repairing Caster Tire/Tube ƽ WARNING Replacement of caster tire or tube MUST be performed by a qualified technician. CAUTION As with any vehicle, the wheels and tires should be checked periodically for cracks and wear, and should be replaced. Installing/Removing Rear Wheels Quick-Release NOTE: For this procedure, refer to FIGURE 8.2. NOTE: To remove rear wheels, reverse this procedure. 1. Push in the detent pin of the quick-release axle and insert the quick-release axle through the center of the rear wheel. 2. Push in the tip of the quick-release axle again and insert the axle (with wheel) into the axle mounting plate on the side of the wheelchair frame until the assembly locks in place. ƽ WARNING Make sure detent pin and locking pins of the quick-release axles are fully released BEFORE operating the wheelchair. The locking pins MUST be protruding past the inside of the axle mounting plate for a positive lock. Keep locking pins clean. 3. Ensure quick release axle locking pins are properly engaged and secure in the axle mounting plate by pulling the rear wheel away from the wheelchair frame. If the locking pins DO NOT engage or there is too much movement of the rear wheel assembly in a back and forth position refer to Adjusting the Quick-Release Axle on page 59. 4. Repeat STEPS 1-3 for other rear wheel assembly. 5. Adjust the wheel locks. Refer to Wheel Lock Adjustment on page 61. Wheelchair Frame Locking Pins Detent Pin Quick-Release Axle Wheel Mounting Bracket Rear Wheel FIGURE 8.2 Installing/Removing Rear Wheels - Quick-Release Compass™SPT™ 58 Part No 1122134