Invacare SPT Owners Manual - Page 51

Installing/Replacing Seat Positioning Straps, Installing, Replacing

Get Invacare SPT PDF manuals and user guides View all Invacare SPT manuals
Add to My Manuals
Save this manual to your list of manuals

Page 51 highlights

SECTION 6-BACK/SEAT Installing/Replacing Seat Positioning Straps NOTE: For this procedure, refer to FIGURE 6.5. Installing 1. Remove the hex screw and locknut that secures the back cane to the back plate. 2. Position the seat positioning strap against the back plate. 3. Install the hex screw through the seat positioning strap, coved spacers and back cane. 4. Securely tighten the seat positioning strap to the wheelchair with the locknut. 5. Repeat STEPS 1-4 for opposite side. Replacing 1. Remove the hex screw, locknut and seat positioning strap from the back plate of the wheelchair frame. 2. Discard existing seat positioning strap. 3. Install the new seat positioning strap to the wheelchair. Refer to Installing/Replacing Seat Positioning Straps on page 51. Back Plate Back Cane Seat Positioning Strap Hex Screw Locknut Coved Spacers FIGURE 6.5 Installing/Replacing Seat Positioning Straps Part No 1122134 51 Compass™SPT™

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
SECTION 6—BACK/SEAT
Part No 1122134
51
Compass™SPT™
Installing/Replacing Seat Positioning Straps
NOTE: For this procedure, refer to FIGURE 6.5.
Installing
1.
Remove the hex screw and locknut that secures the back cane to the back plate.
2.
Position the seat positioning strap against the back plate.
3.
Install the hex screw through the seat positioning strap, coved spacers and back cane.
4.
Securely tighten the seat positioning strap to the wheelchair with the locknut.
5.
Repeat STEPS 1-4 for opposite side.
Replacing
1.
Remove the hex screw, locknut and seat positioning strap from the back plate of the
wheelchair frame.
2.
Discard existing seat positioning strap.
3.
Install the new seat positioning strap to the wheelchair. Refer to Installing/Replacing
Seat Positioning Straps
on page 51.
FIGURE 6.5
Installing/Replacing Seat Positioning Straps
Seat Positioning Strap
Hex Screw
Locknut
Back Plate
Back Cane
Coved Spacers