Invacare SPT Owners Manual - Page 35

SECTION 4-FRONT RIGGINGS Composite/Articulating Footplate Heel Loop Replacement NOTE: For this procedure, refer to FIGURE 4.8. Disassembly Composite. 1. Remove the hex screw and coved spacer that secure the lower footrest assembly to the swing away footrest assembly. 2. Remove the lower footrest assembly. 3. Remove the mounting screw and locknut that secure the heel loop to the footrest. 4. Slide heel loop off of the footrest. Articulating. 1. Remove the mounting screws, washers and spacers that secure the heel loop to the articulating footplate. Reassembly 1. Replace heel loop. 2. Reverse the disassembly procedures. NOTE: When securing the heel loop to the footrest assembly, tighten mounting screw until the spacer is secure. COMPOSITE FOOTPLATE Swingaway Footrest Assembly Philips Screw Hex Screw and Coved Spacer Lower Footrest Assembly Philips Screw Spacer Heel Loop Locknuts Spacer Washer Heel Loop ARTICULATING FOOTPLATE FIGURE 4.8 Composite/Articulating Footplate Heel Loop Replacement Installing/Removing Elevating Legrests NOTE: For this procedure, refer to FIGURE 4.9 on page 36. Installing 1. Place elevating legrest on the outside of the wheelchair and insert mounting pin into the mounting tube. 2. Rotate elevating legrest toward the inside of the wheelchair until it locks in place. NOTE: The calfpad of the legrest will be on the inside of the wheelchair when locked in place. 3. Repeat STEPS 1-3 for the other elevating legrest assembly. Part No 1122134 35 Compass™SPT™