Invacare TDXSP Owners Manual 4 - Page 28

5 USAGE 5.4 Installing/Removing Front Riggings ƽ CAUTION If front riggings are used, then the seat MUST be adjusted to the highest mounting position - otherwise damage may occur. Installing 1. If necessary, remove the footboard. Refer to owner's manual shipped with the wheelchair. 2. Turn front rigging to the side (open footplate is perpendicular to wheelchair) and position mounting holes in the front rigging hinge plates with hinge pins on the wheelchair frame. 3. Install the front rigging hinge plates onto the hinge pins on the wheelchair frame. 4. Push the front rigging towards the inside of the wheelchair until it locks into place. Telescoping Front Rigging Support  The footplate will be on the inside of the wheelchair when locked in place. Hinge Pins 5. Repeat STEPS 1-4 for opposite side of wheelchair. Removing 1. Push the front rigging release lever inward and rotate the footrest out. 2. Lift up on front rigging and remove from the wheelchair. 3. Repeat STEPS 1-2 for opposite side of wheelchair. Front Rigging Release Lever Front Rigging Hinge Plate FIGURE 3 Installing/Removing Front Riggings Invacare® Van Seat 28 Part No 1143195