Invacare TDXSP Owners Manual 4 - Page 31

PHWH93 1. Remove any accessory from the footrest(s).  Lay the footrest on a flat surface to simplify this procedure. 2. Remove the footrest from the wheelchair. Refer to Installing/ Removing Front Riggings on page 28. 3. Remove the hex bolt, washers and locknut that secure the lower footrest assembly to the upper footrest support (FIGURE 1). 4. Reposition the lower footrest to the desired height. 5. Reinstall the hex bolt, washers and locknut that secure the lower footrest to the footrest support and tighten securely. 6. Repeat STEPS 1-5 for the opposite wheelchair footrest, if necessary. 7. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/ Removing Front Riggings on page 28. 8. Reinstall any accessory onto the footrest(s). PH904A and PHAL4A 1. Loosen, but DO NOT remove, the lug bolt and locknut that secure the lower footrest to the footrest support. 2. Reposition the lower footrest to the desired height. 3. Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support. 4. Repeat STEPS 1-3 for the opposite side of the wheelchair footrest, if necessary.  PH904A style front rigging shown. PHAL4A front rigging adjusts the same way. Part No 1143195 31 6 ADJUSTMENT Footrest Support Locknut Coved Washer Coved Washer Hex Bolt Lower Footrest FIGURE 1 Footrest Height Adjustment - PHWH93 Footrest Support Locknut Lower Footrest Lug Bolt FIGURE 2 Footrest Height Adjustment Invacare® Van Seat