Invacare TREX26RP User Manual - Page 33
Fixed Frame, Raising/Lowering Elevating Legrest Assembly
View all Invacare TREX26RP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Fixed Frame 1. Remove impact guards and/or calf strap, if necessary. 2. Loosen, but do not remove the bolt and locknut that secure the lower footrest assembly to the upper footrest support. 3. Reposition the lower footrest assembly to the desired height. 4. Securely tighten the bolt and locknut. 5. Repeat this procedure for the other footrest, if necessary. 6. Replace impact guards and/or calf strap, if necessary. 5.3 Raising/Lowering Elevating Legrest Assembly ƽ WARNING Ensure hands and fingers are clear of elevating legrest mechanism before pushing release lever to lower the elevating legrest. Otherwise injury may occur due to pinch points. The wheelchair user's leg MUST be supported by an assistant before attempting to lower legrest. 1. To raise the elevating legrest, the assistant should hold the support tube and raise the elevating legrest until the desired height is obtained. 2. To lower the elevating legrest, perform the following: A. Support user leg with one hand. B. Push release lever downward with other hand. C. Gently, lower user leg down and rest against the legrest. Part No 1110546 33 5 FRONT RIGGINGS Wheelchair Frame Footplate Assembly Bolt and Locknut FIGURE 4 Adjusting Footplate Height - Fixed Frame Release Lever Support Tube FIGURE 5 Raising/Lowering Elevating Legrest Assembly Invacare® Tracer™ EX2 Wheelchair