JVC DT-V17G15Z Instruction Manual - Page 6
Installation
View all JVC DT-V17G15Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation ● Do not rest your arm on the monitor or lean against the monitor. ● Do not touch the LCD panel when installing the monitor. ● Be sure to install the monitor securely to prevent the monitor from falling over, which may cause damage to the monitor or injury. ● How to set up 1 You can tilt the monitor as follows. When the monitor is not tilted (0°), the guidelines align as illustrated below. Monitor Guidelines ● To detach the stand Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel from being damaged. Attachment screws Screw holes for stand attachment Stand body Approx. 12° 0° Approx. 8° Stand ● Be careful not to pinch your fingers in the gap between the monitor and the stand. ● When the stand plate is attached to the lower position of the stand body, you cannot tilt the monitor downward. ● How to set up 2 When the stand plate is attached to the higher position of the stand body, you can place the monitor as illustrated below. 1 Remove the screws on the sides of the stand (see the following illustration), and lift up the stand until it stops. Screw (silver) Approx. 144° Monitor ● To install the stand When attaching the stand to the monitor, insert the guides of the stand plate into the guide holes on the monitor to place the stand in the correct position. Then fix the stand firmly with the attachment screws. Guide holes 2 Attach the removed screws and place the monitor as illustrated below. Guides Monitor Screw holes for stand attachment Stand plate ● To place the monitor as shown in "How to set up 1" again, remove the screws on the sides of the stand, align the guidelines, and then reattach the screws. Cautions ● When lifting up the stand... - Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel from being damaged. - Be careful not to pinch your fingers in the moving parts. ● Make sure of lifting the stand up until it stops (Approx. 144°); otherwise the monitor may fall over. ● Place the monitor on a mat to avoid scratching the table surface. ● Do not lift up the stand when the stand plate is attached to the lower position of the stand body. Stand body ● To adjust the stand height To change the stand height, detach the stand from the monitor. Then, change the position of the stand plate according to the stand height you want by choosing the screw holes to use. Screw holes for higher position Stand plate Screw holes for lower position Stand plate 6