JVC TK-C2301WPRU Instruction Manual - Page 12

Introduction Operating Precautions m Storage and Location of Use v Do not install the camera in the following places. - In a place with vapor or oil, for example in a kitchen. - When the ambient temperature rises above or falls below the acceptable range (from -10 f to 50 f) - In a place at which corrosive gases are emitted. - Near a source of radiation, X-rays, strong radio waves or magnetism. - In a place, such as vehicle installation, which is subject to vibration. - In a place with excessive dirt. v Using this unit in the vicinity of the transmitting antenna of a radio or TV, devices that emit strong electromagnetic waves such as a transformer or motor, or wireless devices such as a transceiver or mobile phone may give rise to noises in the image and changes in its color. v Do not install in an environment where there is cold air or near the air outlet of an air conditioner. The dome cover may become foggy as a result of sudden temperature changes. v Set up this unit with the height of 16 m or lower. v Though this camera is IP66 compliant, there is no guarantee against water seepage under any circumstances. (IP66 evaluation was not conducted by UL.) m Maintenance v Clean the dome cover lens using a lens wiper cloth (or a tissue). For tough stains, wipe with a neutral detergent diluted with water, followed by wiping with a dry cloth. Do not use benzene or thinner to wipe the camera. Doing so may melt the surface or cause it to fog. v Replace the IR LED unit every 3 years if it is used for 8 hours per day. v Replace the silica gel every 2 years. m Energy Conservation v When the camera is not in use for a long time, turn off the power for safety and energy conservation reasons. E-12