Jensen VM8013HD Operation Manual - Page 7

VM8013HD WIRING NOTE: The amplifier in this radio is only designed for use with four NOTE: Only connect speakers with a nominal impedance speakers. Never combine (bridge) outputs for use with two of 4 ohms. Speakers with a load impedance less than 4 speakers. Never ground negative speaker leads to chassis ground. ohms could damage the unit. SAT BUS SAT R (Red) SAT L (White) Antenna Fuse (15A) Subwoofer Out Parking Brake (Pink) (Blue) Camera In Video Out 1 (Yellow) (Yellow) Video Out 2 (Yellow) Camera/Active High Level Input (Green/White) + SWC (Steering Wheel Control) (Requires PAC SWI-PS Interface Adapter) IPOD BUS () (+) JXMC or XMDJEN100 Cables (sold separately) Satellite Radio Tuner (sold separately) jLink iPod Cable (Included) - Battery Connect the yellow wire to the battery or 12 volt power source that is always live. This wire MUST be connected for the radio to work. Rear Line out Gray Front Line out R (Red) L (White) R (Red) Black L (White) Yellow Chassis Ground Black FILTER BOX Connect the black wire to the factory ground wire. If a factory ground wire is not provided, locate a clean, unpainted metal part of the dash and secure the ground wire with a "ring" terminal and a sheet metal screw. iPod NOTE: Video playback not supported for all (Sold Separately) iPods. See iPod section for more information. White/Black Stripe White Gray/Black Stripe FRONT Gray Power Antenna Connect to power antenna or amplifier. If not used, tape bare end of wire. Blue Accessory/Ignition Connect to existing radio wire or radio fuse. REAR Green/Black Stripe Red Green Purple/Black Purple Stripe IMPORTANT! The pink parking wire MUST be connected to the switched side of the parking break circuit (the part that becomes grounded when the brake is applied). Left Speaker (Front) Right Speaker (Front) Left Speaker (Rear) Right Speaker (Rear) 3