Kenmore 4500 Use and Care Guide - Page 15

Setting Oven Controls Setting the Clock The _ pad is used to set the clock. The clock may be set for 12 or 24 hour time of clay operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash (See Fig, 1), INSTRUCTIONS To set the clock (example below for 1:30) 1, Press @. "CLO" will appear in the display (Figure 2), 2, Press (_ (_ (_ pads to set the time of day to 1:30 (Figure 3). "CLO" will stay in the display, Press will disappear and the clock will start (Figure 4), "CLO" Changing between 12 or 24 hour time of day display 1, Press and hold @ for 7 seconds. "CLO" will appear in the display. After 3 seconds i_1will appear in the display indicating that the cooktop lockout is active (Figure 5). CONTINUE holding the pad until "12h" (Figure 6) or "24h" (Figure 7) appears in the display and the control beeps once. 2. Press _ to switch between the 12 and 24 hour time of day v display. The display will show either "12h" (Figure 6) or "24h" (Figure 7). 3. Press to accept the change or press _ to reject the change. I_1will disappear from the display. 4. Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours. PRESS O dbQdb 0 for 7 seconds @ @ Figure 1 DISPLAY Figure 2 Figure 3 Figure 4 Figure 5 Figure 6 Figure 7 ...ii.i...... 15