Kenmore 7800 Installation Instructions - Page 4

Product Dimensions I I I I G \ A. 35%" (91.1 cm) cooktop height (minimum) with leveling legs screwed all the way in* B. Model/serial/rating plates (located behind the control panel)** C. 463/4" (118.7cm) overall height (minimum) with levering legs screwed all the way in* D. 28W' (71.3 cm) depth with handle E. 26%6" to 27¼" (66.8 to 69.2 cm)*** E 29%" (75.9 cm) width *Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs. **Model/serial/rating plates may be rotated up from behind the control panel for viewing from the front of the range. ***Excludes handle. Dimension given is from wall to front of oven door and will vary based on electric outlet receptacle installation. Cabinet Dimensions Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height. IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface. Range may be installed with zero clearance to combustible construction at the rear and on the sides below the cooktop. 10" (25.4 cm) 1¼"* (3.1 cm) (5.7_ A. 18" (45.7 cm) upper cabinet to countertop B. 13" (33.0 cm) upper cabinet depth C. 30" (76.2 cm) min. opening width D. For minimum clearance to the top of the cooktop, see NOTE. E. 30" (76.2 cm) min. opening width F. 3" (7.6 cm) min. clearance from both sides of the range to the side wall or other combustible materiaL G. 3" (7.6 cm) distance from wall H. Cabinet door or hinges should not extend into the cutouL I. Clearance for gas pressure regulator *Drill on centerline 11A'' (3.1 cm) from rear wall for gas supply line. **Gas lines and electrical plugs must be installed within the shaded area to ensure proper alignment of this oven with cabinets. NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet is protected by not less than 1/4"(0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. 30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.