Kenmore 7857 Use and Care Guide - Page 21

PRODUCT DATA SHEETS Interior Water Filtration System Model 469006-750 Capacity 750 Gallons (2839 Liters) System tested and certified by NSF International against NSF/ANSI Class I*; and against NSF/ANSI Standard 53 for the reduction of Lead, SMtaenrcduarryd, A4t2razfoinre,theBerendzuecnteio,n p-oDficChhlolororibneenzeTnaes,te anCdarObodfour,anP, articulate Toxaphene, Cysts, Turbidity, Asbestos and Lindane. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53. Substance Reduction Aesthetic Effects Chlorine Taste/Odor Particulate Class I* Contaminant Reduction Lead: @ pH 6.5 Lead: @ pH 8.5 Mercury: @ pH 6.5 Mercury: @ pH 8.5 Benzene p-Dichlorobenzene Carbofuran Toxaphene Atrazine Asbestos Live Cysts _ Turbidity Lindane NSF Reduction Requirements 50% reduction 85% reduction NSF Reduction Requirements 0.010 mg/L 0.010 mg/L 0.002 mg/L 0.002 mg/L 0.005 mg/L 0.075 mg/L 0.04 mg/L 0.003 mg/L 0.003 mg/L 99% >99.95% 0.5 NTU 0.0002 mg/L Average Influent 1.88 mg/L 5,700,000 #/mL Average Influent 0.153 mg/U 0.150 mg/U 0.006 mg/L 0.006 mg/L 0.014 mg/L 0.208 mg/L 0.081 mg/L 0.015 mg/L 0.009 mg/L 155 MF/L 166,500 #/L 10.7 NTU 0.002 mg/L Influent Challenge Concentration 2.0 mg/L _+10% At least 10,000 particles/mL Influent Challenge Concentration 0.15 mg/L + 10% 0.15 mg/L _+10% 0.006 mg/L + 10% 0.006 mg/L _+10% 0.015 mg/L _+10% 0.225 mg/L _+10% 0.08 mg/L _+10% 0.015 _+10% 0.009 mg/L _+10% 107to 108fibers/U _ 50,000/L min. 11 _+1 NTU 0.002 _+10% Maximum Effluent 0.06 mg/L ** 69,000 #/mL Maximum Effluent < 0.001 mg/L < 0.001 mg/L 0.0005 mg/L 0.0015 mg/L 0.0011 mg/L < 0.0005 mg/L < 0.001 mg/L < 0.001 mg/L < 0.002 mg/L 99.29% 0.0003 mg/L 90.91 0.0008 mg/L 75.93 0.0006 mg/L 92.14% < 0.0005 mg/L 99.74% < 0.001 mg/L 98.46% < 0.001 mg/L 91.67% < 0.002 mg/L 75.31% 99.99% 99.99 95.2 0.000 mg/L 96.50% Average% Reduction >97.26 99.52 Average% Reduction >99.35% >99.33% 95.70 86.22 95.71% 99.76% 98.74% 92.97% 76.99% >99.99% >99.99 97.09 98.72% Test Parameters: pH = 7.5 _+0.5 unless otherwise noted. Flow = 0.78 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). • It is essential that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. • The disposable water filter should be replaced at least every 6 months. The filter monitor system measures the amount of water that passes through the filter and alerts you to replace the filter. When 90% of the filter's rated life is used, the yellow (Order) light comes on. When 100% of the filter's rated life is used, the red (Replace) light comes on, and it is recommended that you replace the filter. For models without filter status lights, replace the filter every 6 months. Use replacement filter model 469006-750.2007 suggested retail price of $49.99 U.S.A./S65.95 Canada. Prices are subject to change without notice. • Refer to the "Water Filtration System" section for the Manufacturer's name and telephone number. • Refer to the "Warranty" section for the Manufacturer's limited warranty. Application Guidelines/Water Supply Parameters Water Supply Water Pressure Water Temperature Service Flow Rate City or Well 35 - 120 psi (241 - 827 kPa) 33 ° - 100°F (1o _ 38oC) 0.78 gpm (2.9 L/min.) @ 60 psi. The product is for cold water use only. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. *Class I particle size: >0.5 to