Kenwood DDX4017BT Instruction Manual - Page 66
Installing the unit
View all Kenwood DDX4017BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
CONNECTION/INSTALLATION ❏ Supplied accessories for installation 1 Wiring harness x 1 2 Trim plate *1 x 1 3 Extension wire (2 m) x 1 4 Flat head screws (M5 x 8 mm) x 6 *2 5 Round head screws (M5 x 8 mm) x 6 6 Steering Remote cable x 1 7 Microphone (3 m) x 1 8 Fixture for HDMI/MHL connector x 1 *3 9 Screws for the fixture (M2.6 x 6 mm) x 1 *3 *1 Only for DDX7017BT Region 4/DDX4017BT. *2 Only for DDX7017BT/DDX7017BTM/DDX4017BT/DDX417BT/ DDX417BTM. *3 Only for DDX7017BT/DDX7017BTM/DDX717WBT/DDX717WBTM. ❏ Installation procedure 1 To prevent a short circuit, remove the key from the ignition and disconnect the · battery. 2 Make the proper input and output wire connections for each unit. 3 Connect the speaker wires of the wiring harness. 4 Connect the wiring harness wires in the following order: ground, battery, ignition. 5 Connect the wiring harness connector to the unit. 6 Install the unit in your car. • Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). 7 Reconnect the · battery. 8 Press the reset button. (Page 3) 9 Configure . (Page 4) Installing the unit ❏ Installing the unit using the mounting bracket removed from the car 4 or 5 Car Bracket 4 or 5 • Select the appropriate type of screw for the mounting bracket: flat head (4) or round head (5). ❏ Installing the trim plate (Only for DDX7017BT Region 4/DDX4017BT) 1 Attach the trim plate (2). 2 66