Kenwood DDX4018DAB Instruction Manual - Page 37
<Fader/Balance>, Setting the speakers and crossover, frequency, <Speaker/X'over>,
View all Kenwood DDX4018DAB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Settings *2 Restores the sound lost due to audio compression to a realistic sound. • OFF/ON (Initial) Virtually makes the sound more realistic using the Digital Signal Processor (DSP) system. Select the sound level. • OFF (Initial)/Level 1/Level 2/Level 3 Moves the center of the sound to the lower or higher point. Select the height. • OFF (Initial)/Low/Middle/High *1 You cannot change the setting when "Radio" or "DAB" (only for DDX4018DAB) is selected as the source. *2 This function works only when "DISC"/ "USB"/ "iPod"/ "Android™" is selected as the source. Touch [J]/[K]/[H]/[I] or drag the mark to adjust. Adjusts the front and rear speaker output balance. When using a two-speaker system, set the fader to the center (0). • F15 to R15 (Initial: 0) Adjusts the left and right speaker output balance. • L15 to R15 (Initial: 0) To clear the adjustment: Touch [Center]. screen. 4 Select the crossover network mode. [2way] Select this when connecting speakers in a 2-way system (front/rear). [3way] Select this when connecting speakers in a 3-way system (tweeter/mid range/woofer). A confirmation message appears. Touch [Yes] to confirm. Setting the speakers and crossover frequency 1 Select a car type (1), select the location of the speakers (2), then display the screen (3). • Speaker location selection is available only when screen (3). • If a speaker is not connected, select . • When setting the front speakers, also select the speaker size for . ENGLISH 33