Kenwood DDX4018DAB Instruction Manual - Page 48
Removing the unit, Installing the unit, Installing the trim plate, Parts list for installation,
View all Kenwood DDX4018DAB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Installation and Connection Parts list for installation Note: This parts list does not include all the package contents. ¥ Wiring harness (× 1) ø Extension wire, 2 m (× 1) π Microphone, 3 m (× 1) [ Trim plate (× 1) " Mounting sleeve (× 1) ] Extraction keys (× 2) 8 Reconnect the · battery. 9 Press the reset button on the monitor panel. (Page 4) 10 Configure . (Page 5) Installing the unit Installation procedure 1 Remove the key from the ignition and disconnect the · battery. 2 Make the proper input and output wire connections for each unit. 3 Connect the speaker wires of the wiring harness. 4 Take Connector B on the wiring harness and connect it to the speaker connector in your vehicle. 5 Take Connector A on the wiring harness and connect it to the external power connector in your vehicle. 6 Connect the wiring harness connector to the unit. 7 Install the unit in your car. Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (e.g., the sound may skip). Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. Installing the trim plate 44 ENGLISH Removing the unit 1 Engage the catch pins on the extraction keys (]) and remove the two locks on the lower part of the trim plate ([). Catch Lock 2 Remove from the upper two catches of the trim plate ([). The frame can be removed from the top side in the same manner. 3 Remove the unit by inserting the two extraction keys (]), then pulling them as illustrated. Be careful to avoid injury from the catch pins on the extraction key.