Kenwood KTC-SR902 Instruction Manual - Page 14

English Accessories 1 4 2 5 3 Installation Procedure 1. To prevent short circuits, remove the key from the ignition and disconnect the - terminal of the battery. 2. Install the Sirius antenna and connect the antenna wire to the Sirius satellite radio tuner. 3. Connect the Sirius satellite radio tuner and the control unit using the provided Sirius connection wire. 4. Make the proper input and output wire connections for each unit. 5. Install the unit in your car. 6. Reconnect the - terminal of the battery. 7. Press the reset button on the control unit. 2CAUTION The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the accessories shipped with the unit, as shown above. 2CAUTION • Do not connect the Sirius control wire while the control unit is turned ON. • Be sure to press the reset button on the control unit after installation. • If your car is not prepared for this special connection-system, consult your Kenwood dealer. • Make sure that all wire connections are securely made by inserting jacks until they lock completely. • Do not let unconnected wires or terminals touch metal on the car or anything else conducting electricity. To prevent short circuits, also do not remove the caps on the ends of the unconnected wires or the terminals. • Insulate unconnected wires with vinyl tape or other similar material. • Take care so that the antenna wire and other connection wires are not caught by mobile parts. Otherwise wire disconnection or other trouble may result. • Do not apply too much force on the antenna wire, other connection wires and connectors by bending a wire, etc. Otherwise wire disconnection or other trouble may result. • After the unit is installed, check whether the brake lamps, indicators, wipers, etc. on the car are working properly. - 14 -