Kenwood KTC-SR902 Instruction Manual - Page 18
Troubleshooting Guide, may just be the result of slight misoperation or - antenna error
UPC - 019048148049
View all Kenwood KTC-SR902 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
English Troubleshooting Guide If you use this for the first time, it may be difficult to receive signals in the beginning. In such a case, leave the SIRIUS source ON for 3 minutes and turn it OFF and ON. What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. ? The Sirius mode cannot be selected. ✔ The Sirius connection wire is not connected. ☞ Use the Sirius connection wire to connect the control unit and the Sirius satellite radio tuner. ✔ The PROTOCOL selection switch of the changer switching unit "KCAS210A" is not set properly. ☞ Set the PROTOCOL selection switch to "N" position. ✔ The changer switching unit "KCA-S210A" is not connected properly. ☞ Connect the KTC-SR902 to the terminal labelled TO CHANGER 2. See the section on . ? Nothing happens when the buttons are pressed. ✔ The computer chip in the unit is not functioning normally. ☞ Press the reset button on the Control/Controller unit . ? No sound can be heard, or the volume is low. ✔ The input/output wires or wiring harness are connected incorrectly. ☞ Reconnect the input/output wires and/or the wiring harness correctly. See the section on . ? No broadcast can be received. ✔ The Sirius antenna is not connected. ☞ Connect it properly by referring to . ✔ No subscription is established. ☞ Subscribe to SIRIUS. The following messages are displayed when certain problems are occurring in your system. Take the recommended actions. ANTENNA ERROR / ANT ERR / ANT ERROR: Antenna is not connected correctly. ➪ Make sure the antenna is connected correctly and then turn OFF/ON of the SIRIUS source or Control unit. TUNER ERROR / TUNE ERR : Broadcast cannot be received due to an error in this unit. ➪ Turn OFF/ON of the SIRIUS source or Control unit, or press the reset button of Control unit. ESN ERROR / ESN ERR : ESN (Electronic Serial Number) is not registered in this unit. ➪ Consult your nearest service center. - 18 -