Kenwood KTC-SR902 Instruction Manual - Page 5

Operations from Model-A Control Unit When you have the model-A control unit categorized by the (page 4), follow the operation instructions given below. Selecting the Preset Band Press the [FM] button. Each time the button is pressed the preset band switches between the SR1, SR2, SR3 and SR4. Sirius ID [ESN] display You must have the Sirius ID number [ESN] for licensing with Sirius Corp. Check the Sirius ID [ESN] of this unit as follows. 1 Select the Sirius Satellite Radio Mode Press the [SRC] button. Select the "SIRIUS" display. 2 Check the Sirius ID [ESN] of this unit See the page of the instruction manual of your control unit, and select the ESN menu item. The Sirius ID [ESN] will be displayed. Serial & Sirius ID [ESN] It is especially important to retain the unit serial number and the electronic Sirius Identification number for service activation and potential future service changes. Select Sirius Satellite Radio Mode Listening to the satellite radio. Press the [SRC] button. Select the "SIRIUS" display. • You need to subscribe to SIRIUS to receive the service by Sirius Satellite Radio. Consult SIRIUS if "CALL 888-539 SIRIUS TO SUBSCRIBE"/"CALL 888 539-SIRI" appears. • It may take a little time to start receiving after you selected the SIRIUS source. • If the signal receiving fails, "Acquiring Signal" appears. Tuning Selecting the channel. Press the [4] or [¢] button. Channel Preset Memory Putting the channel in the memory. 1 Select the preset band Press the [FM] button. 2 Select the channel to put in the memory Press the [4] or [¢] button. 3 Put the channel in the memory Press the [1] - [6] button for at least 2 seconds. The preset number display blinks 1 time. On each band, 1 channel can be put in the memory on each [1] - [6] button. • Only the channel number is stored. Category information is not stored. • This function can be used only when the "Channel" has been selected in (page 6). -5-