Kenwood LSF-1010 User Manual - Page 21

Clip-on Mount Use the following procedure to clip the speaker onto an object other than the base.You can clip to either a cylindrical fixture (such as a thin pipe) or a flat-edge fixture (such as the edge of a bookshelf). Conditions If flat: Width should be 12 to 15 mm (about 0.5 to 0. 6 inches) If cylindrical: Diameter should be 12 to 20 mm (about 0.5 to 0.8 inches). Other Ways to Set Up the Satellite Speakers 21 LSF-1010 (EN) For information about how to remove/replace the screw caps and loosen the arm screws, see page 16, "Getting Ready to Adjust." 1. Remove the arm. Loosen the screws. 1 Loosen the two arm screws and pull the arm out. • Unplug the cord from the jack before removing the arm. • If you want to change the angle of the arm, set the arm holders to the appropriate angle. For instructions, see page 17, "Adjusting the Arm Angle." FRANÇAIS DEUTSCH NEDERLANDS 2. Clamp the clip onto an appropriate object. 1 Unclamp the clip from the stand, and clamp it onto an appropriate flat edge or cylinder. • If clipping to a flat edge, set so that the entire rubber part of the clip makes contact with the flat surface. • If clipping to a cylinder, set so that the rubber part fits (curves) around the cylinder. 2 Gently push the clip up, down, right, and left to confirm that it is securely fixed in place and maintains its position. Many objects are not suitable as supports - either because the material is not strong enough or because the surface does not allow an adequate grip. Do not clip to any object that does not offer sufficient stability. (To be continued.) ITALIANO ESPAÑOL