Kenwood LSF-1010 User Manual - Page 8

FRANÇAIS DEUTSCH 8 Setting Up the Satellite Speakers For standard setup, mount each speaker to a stand as described below. As an alternative to the standard setup, it is also possible to mount the speakers onto a wall or to set them up without the stand. For information about setup alternatives, see page 18, "Other Ways to Set Up the Satellite Speakers." FIRST: Attach speaker cord. Connect speaker cord to the terminals on the bottom of the stand base. Use a coin or screwdriver to turn loosen the screws. Remove the plastic insulation from each wire tip, and twist the exposed metal wire. Curl the wire around the thin part of the corresponding screw, and then tighten the screw. White stripe Set the cord into cord cramp. 1. Attach the speaker to the arm. LSF-1010 (EN) Use the speaker screw and washer removed from the satellite speaker to make the attachment. Satellite speaker Washer Screw 1 Remove the screw and washer from the rear of the satellite speaker. Cord Washer 2 Pass the cord through the arm. Screw 3 Use the screw and washer to fasten the speaker to the arm. Arm Cord Pass the cord through the arm. Adjusting the Speaker Angle Location of screw controls the angle. You can adjust the angle of the speaker by moving the screw to a different location on the arm. NEDERLANDS ITALIANO ESPAÑOL Be sure that the screw head makes contact with metal only, not with plastic insulation.