Kenwood LSF-1010 User Manual - Page 22

ESPAÑOL ITALIANO NEDERLANDS DEUTSCH FRANÇAIS 22 3. Attach and fasten the arm. 1 Fit the arm through the holes in the arm holders, adjust it to the desire height, and then tighten the arm screws. 2 Place the screw caps back over the arm screws. You may now want to readjust the angle of the speaker on the arm. You can do this by loosening the screw holding the speaker to the arm, repositioning the screw, and then retightening it. See "Adjusting the Speaker Angle," on page 8. 4. Connect the satellite speaker to the base of the stand using separately purchased extension speaker cord. • Use cord that has a mini-plug (3.5-mm) at one end and a mini-jack (3.5-mm) on the other. Do not connect the wire from the speaker directly to an amp; the connection must be relayed through the base. Extension speaker cord Other Ways to Set Up the Satellite Speakers LSF-1010 (EN)