KitchenAid KBSN702MBS Owners Manual - Page 18
Connect the Water Supply, Move the Refrigerator into House, Install Anti-Tip Boards
View all KitchenAid KBSN702MBS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
1. Grasp both ends of the top grille. 2. Push the top grille straight up; then pull straight out. Lay the grille on a soft surface. A. Top grille B. Cabinet side trim 3. Remove the 6 screws attaching each cabinet side trim to the refrigerator and remove the side trims. Move the Refrigerator into House WARNING Tip Over Hazard Refrigerator is top heavy and tips easily when not completely installed. Keep doors taped closed until refrigerator is completely installed. Use two or more people to move and install refrigerator. Failure to do so can result in death or serious injury. 1. Place an appliance dolly under the left side of the refrigerator as shown. Place the corner posts from the packing materials over the trims as appropriate. Slowly tighten the strap. NOTE: Pass the dolly strap under the handles for the Stainless Series. 3. Place top of cardboard carton or plywood under refrigerator. 4. Stand the refrigerator up. First, place the left bottom edge of the refrigerator on the floor, stand the refrigerator upright and then lower the right-hand side of the refrigerator to the floor. 5. Reassemble the trim and top grille after the dolly has been removed from the refrigerator. Install Anti-Tip Boards IMPORTANT: � If a solid soffit is not available, anti-tip boards must be installed. � It is recommended that boards be installed before the refrigerator is installed. � Boards must be long enough to fully cover the width of the compressor cover. � Place the boards so that the bottom surfaces of the boards are 84" (213 cm) from the floor. � During installation, raise the refrigerator up until the top of the refrigerator is making contact with the bottom of the anti-tip boards. Do not crush the compressor cover when raising the rear leveling legs. NOTE: The foam gasket, on top of the compressor cover, will compress to fit under the anti-tip board(s). There is no need to trim the gasket. To Install Anti-tip Boards 1. Mark the stud locations on rear wall. 2. Securely attach two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards to wall studs behind refrigerator. Use six #8 x 3" (7.6 cm) (or longer) wood screws. The wood screws must be screwed into the studs at least 1½" (3.8 cm). The boards must overlap the compressor cover. A B C 2" (5 cm) 2. Place pieces of the shipping carton on the floor when rolling the dolly and refrigerator into the house. Move the refrigerator close to the built-in opening. 18 D A. Center board 1/4" (6.35 mm) max. above refrigerator B. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards C. Attach to studs with six #8 x 3" (7.6 cm) screws D. Compressor cover Connect the Water Supply Read all directions before you begin. IMPORTANT: � If you turn the refrigerator on before the water line is connected, turn the ice maker OFF. � Connect to potable water supply only.