KitchenAid KBSN702MBS Owners Manual - Page 27
Ice Maker and Storage Bin, Style, Clean the Ice Storage Bin, Remember
View all KitchenAid KBSN702MBS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Ice Maker and Storage Bin IMPORTANT: Flush the water system before turning on the ice maker. See "Water and Ice Dispensers." Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. Allow 3 days to completely fill the ice container. Style 1 To Turn the Ice Maker On/Off: The On/Off switch for the ice maker is a wire shutoff arm located on the side of the ice maker. 1. To turn the ice maker ON, simply lower the wire shutoff arm. NOTE: Your ice maker has an automatic shutoff. As ice is made, the ice cubes will fill the ice storage bin and the ice cubes will raise the wire shutoff arm to the OFF (arm up) position. 2. To manually turn the ice maker off, lift the wire shutoff arm to the OFF (arm up) position and listen for the click to make sure the ice maker will not continue to operate. Style 2 To Turn the Ice Maker On/Off: The On/Off switch is located on the top right side of the freezer compartment. 1. To turn the ice maker on, slide the control to the ON (left) position. NOTE: Your ice maker has an automatic shutoff. The ice maker sensors will automatically stop ice production, but the control will remain in the ON (left) position. 2. To manually turn the ice maker off, slide the control to the OFF (right) position. To Remove and Replace the Ice Bin: 1. Flip up the covering panel. To Remove and Replace the Ice Storage Bin: 1. Hold the base of the storage bin with both hands and press the release button to lift the storage bin up and out. NOTE: It is not necessary to turn the ice maker control to the OFF (right) position when removing the storage bin. The sensor cover ("flipper door") on the left wall of the freezer stops the ice maker from producing ice if the door is open or the storage bin is removed. 2. Replace the storage bin on the door and push down to make sure it is securely in place. A. Ice maker cover 2. Lift the wire shutoff arm so it clicks into the OFF (up) position. Ice can still be dispensed, but no more can be made. 3. Lift up the front of the storage bin and pull the ice bin forward. 4. Replace the bin by pushing it in all the way or the dispenser will not work. Push the wire shutoff arm down to the ON position to restart ice production. Make sure the door is closed tightly. Clean the Ice Storage Bin NOTE: It is normal for ice to stick together in the ice bin. Ice may be dispensed or used more frequently which will break up the ice. It is recommended that the ice container be emptied and cleaned as needed. To clean the ice storage bin: 1. Empty the ice container. Use warm water to melt the ice if necessary. NOTE: Do not use anything sharp to break up the ice in the bin or bucket. This can cause damage to the ice container and the dispenser mechanism. 2. Wash ice bin with a mild detergent, rinse well and dry thoroughly. Do not use harsh or abrasive cleaners or solvents. Remember � Allow 24 hours to produce the first batch of ice. Allow 3 days to completely fill ice container. � Discard the first three batches of ice produced to avoid impurities that may be flushed out of the system. 27