Konica Minolta C83hc High Chroma EF-103 AccurioPress C3080/C3080P/C3070/Print - Page 16

Using Envelopes of 139.7 to 245 mm in Width, Do not move the paper control levers 2 pieces. Other

Get Konica Minolta C83hc High Chroma PDF manuals and user guides View all Konica Minolta C83hc High Chroma manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

2.2 Installation Procedures 2 NOTICE Do not move the paper control levers (2 pieces). Otherwise, the paper feeding performance may degrade. 4 Install the rear assist guide/Lw. % Hit the rear assist guide/Lw to the gap of the rear guide plate. 5 Install the rear assist guide/Up to the rear guide. 6 Push in tray 5 until it locks into place. Using Envelopes of 139.7 to 245 mm in Width Follow the procedure below to use envelopes of the above size. Side auxiliary guides (2 pieces) are not needed. 1 Pull out tray 5. 2 Move each of the small size guides (front/rear) toward the outside the side guide plates. % If the auxiliary guides are installed on the side guides, pull them up to remove them. The positioning screws (4 pieces) installed on the side guides are not required AccurioPress C3080/C3080P/C3070, AccurioPrint C3070L 2-8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
AccurioPress C3080/C3080P/C3070, AccurioPrint C3070L
2-8
2.2
Installation Procedures
2
NOTICE
Do not move the paper control levers (2 pieces). Other-
wise, the paper feeding performance may degrade.
4
Install the rear assist guide/Lw.
%
Hit the rear assist guide/Lw to the gap of the
rear guide
plate.
5
Install the rear assist guide/Up to the rear guide.
6
Push in tray 5 until it locks into place.
Using Envelopes of 139.7 to 245 mm in Width
Follow the procedure below to use envelopes of the above size. Side auxiliary guides (2 pieces) are not need-
ed.
1
Pull out tray 5.
2
Move each of the small size guides (front/rear) toward the
outside the side guide plates.
%
If the auxiliary guides are installed on the side guides,
pull them up to remove them. The positioning screws
(4 pieces) installed on the side guides are not required