Konica Minolta C83hc High Chroma EF-103 AccurioPress C3080/C3080P/C3070/Print - Page 20

Using K2 240 x 332 mm Envelopes

Get Konica Minolta C83hc High Chroma PDF manuals and user guides View all Konica Minolta C83hc High Chroma manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

2.2 Installation Procedures 2 7 Install the guide shaft to the back edge guide base of the bottom auxiliary guide assy [A]. 8 Close the upper door. Using K2 (240 x 332 mm) Envelopes The following parts need to be installed when K2 envelopes are used. - Bottom auxiliary guide assy [A] (1 piece) - Adjusting block assy (2 pieces) - Guide shaft (1 piece) 1 Open the upper door. 2 Remove the holding paper. % Hold the projection with your fingers and slide the holding paper in the arrowed direction, and remove it. 3 Install the bottom auxiliary guide assy [A] in the Large Ca- pacity Unit LU-202m/LU-202XL/LU-202XLm tray. % Align the positioning pin of the bottom auxiliary guide assy [A] with the installation hole of the tray. % Align the detent of the bottom auxiliary guide assy [A] with the groove on the back end guide. AccurioPress C3080/C3080P/C3070, AccurioPrint C3070L 2-12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
AccurioPress C3080/C3080P/C3070, AccurioPrint C3070L
2-12
2.2
Installation Procedures
2
7
Install the guide shaft to the back edge guide base of the
bottom auxiliary guide assy [A].
8
Close the upper door.
Using K2 (240 x 332 mm) Envelopes
The following parts need to be installed when K2 envelopes are used.
-
Bottom auxiliary guide assy [A] (1 piece)
-
Adjusting block assy (2 pieces)
-
Guide shaft (1 piece)
1
Open the upper door.
2
Remove the holding paper.
%
Hold the projection with your fingers and slide the hold-
ing paper in the arrowed direction, and remove it.
3
Install the bottom auxiliary guide assy [A] in the Large Ca-
pacity Unit LU-202m/LU-202XL/LU-202XLm tray.
%
Align the positioning pin of the bottom auxiliary guide
assy [A] with the installation hole of the tray.
%
Align the detent of the bottom auxiliary guide assy [A]
with the groove on the back end guide.