Konica Minolta Kodak i1190 User Guide - Page 29
Replacement procedures, Replacing the separation roller, roller
View all Konica Minolta Kodak i1190 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Replacement procedures Replacing the separation roller Kodak Scanners use replaceable feed roller modules that can feed a wide range of document types, sizes and thicknesses. Module life and performance will vary based on the customer's document set, the frequency of cleaning the paper path and tires, and following the recommended schedule for changing the module. The nominal feed roller module life is approximately 200,000 pages. Usage figures are not guaranteed. Customer-operating environments, document type, the condition of documents being scanned, and not following the recommended cleaning and replacement procedures, can cause the life of the consumables to vary. Change the feed roller module if you notice an increase in multiple feeds, stoppages, or a decrease in feeder performance that is not resolved by following the cleaning procedures. NOTES: • Before replacing parts, disconnect the electrical power. • Certain paper types (such as carbonless paper or newsprint), failure to clean regularly, and/or use of non-recommended cleaning solvents can shorten roller life. 1. Remove the pre-separation pad by grasping it and pulling it out of position. 2. Remove the separation roller. A-61816 August 2016 3. Install the new separation roller by aligning the tab with the slot and snapping it into position. 4. Re-install the pre-separation pad by aligning the slots with the holes on the pre-separation pad and snapping it into place. 23