Konica Minolta Kodak i4200 Plus User Guide - Page 10
Stop/Pause button, Power button, Input Elevator side guides, Input Elevator, extender
View all Konica Minolta Kodak i4200 Plus manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
11 Stop/Pause button - press once to temporarily pause scanning (the Start/Resume button can then be used to resume scanning). Press twice to stop scanning. The red LED on this button indicates a possible error condition has been detected (i.e., document jam). 12 Power button - press to turn the scanner on or press and hold for one second to turn the scanner off. 13 Input Elevator side guides - slide the guides in or out to accommodate the document size you want to scan. Side guides can be left-, center- and right-adjusted to accommodate documents of various widths. The side guides can also be locked into position if desired. 17 11 16 15 12 14 13 14 Input Elevator- holds up to 500 documents (20 lb/80 g/m2) in place. The input elevator can be set to accommodate stacks of 25-, 100-, 250or 500-documents. The input elevator can be folded up when it is not in use. 15 Input Elevator extender - pull this extender out to accommodate documents longer than 35.6 cm (14 inches). 16 Print location indicators - there are detents at the edge of the input elevator to indicate where the print positioning will be on the paper. 17 Gap release toggle switch - push in to adjust the space between the feed module and separation module for documents that require special handling. 4 A-61651 September 2016