Kyocera ECOSYS M3655idn M3655idn/M3660idn Operation Guide - Page 88

Installing and Setting up the Machine > Energy Saver function If print data is received during Sleep, the machine automatically wakes up and starts printing. Also when fax data arrives while the machine is in Sleep, the machine automatically wakes up and starts printing. To resume, perform the following actions. • Select the [Energy Saver] key. The machine will be ready to operate within 25 seconds. Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly. Auto Sleep Auto Sleep automatically switches the machine into Sleep if left idle for a preset time. The default preset time is 1 minute. To change the preset sleep time, refer to the following: Quick Setup Wizard (page 2-35) Sleep Rules (models for Europe) You can set whether sleep mode operates for each function. When the machine enters sleep mode, the ID card cannot be recognized. For more information on Sleep Rules settings, refer to the following: Sleep Rules (models for Europe) (page 8-47) Sleep Level (Energy Saver and Quick Recovery) (models except for Europe) For sleep level, you can toggle between the following two modes: Energy Saver mode and Quick Recovery mode. The default setting is Energy Saver mode. Energy Saver mode reduces power consumption even more than Quick Recovery mode, and allows Sleep Mode to be set separately for each function. The ID card cannot be recognized. NOTE If the optional Network Interface Kit is installed, Energy Saver cannot be specified. For more information on Sleep Level settings, refer to the following: Quick Setup Wizard (page 2-35) Power Off Rule (models for Europe) The Power Off Rule is used to stop the power from automatically turning off. The default preset time is 3 days. For more information on Power Off Rule settings, refer to the following: Power Off Rule (models for Europe) (page 8-48) 2-34