Kyocera KM-8530 KM-8530 Operation Guide - Page 144

Troubleshooting Tips COPIER DOES NOT OPERATE WHEN POWER SWITCH IS ON Fully insert paper trays. Close RADF. Close Front doors of main body. Close Finisher door. Check to be sure main power switch is ON. Check to be sure power plug is firmly inserted in electrical socket. COPY IMAGE IS TOO LIGHT Manually adjust copy density to darker density. Check toner indicator and add toner, if required. Check paper for dampness. Do not leave paper in copier when humidity is high. Check to see if Photo, Text, or Increase Contrast mode is required. Check the Density shift. COPY IMAGE IS TOO DARK Manually adjust copy density to lighter density. Check to see if Photo, Text, or Increase Contrast mode is required. Check the Density shift. COPY IMAGE IS NOT CLEAN OR SHOWS SPOTS Use clean originals since dirt marks may be copied. Keep platen glass and inner surface of document cover clean. Call for service if "Call for service" is displayed in the message area. Check density indicator and lighten if required. COPY PAPER MISHANDLES DURING COPYING Fan copy paper and load it with curl side in proper location. Do not exceed the tray capacity. COPY IMAGE CAN BE RUBBED OFF Check copy paper thickness. Use Thick paper mode, if paper weight requires it. MAGNIFICATION CANNOT BE CHANGED Reduce & Shift is incompatible with magnification. Press [AUTO RESET] and set desired copying conditions without using Reduce & Shift. DUPLEX MODES CANNOT BE SELECTED Fully close RADF, then select Duplex mode again. COPYING DOES NOT BEGIN AFTER PRESSING [START] Insert or adjust the appropriate paper tray for copy size selected. Close document cover firmly. Close Front doors and Toner access door of main body completely. Close Finisher door completely. Check to see if the message "Please close stacker cover of Trimmer" is displayed. Close Trimmer stacker cover or front door completely. 5-14