Kyocera KM-8530 KM-8530 Operation Guide - Page 73

Selecting Copy Size To select an appropriate copy size for getting your desired copy result, use APS (Automatic Paper Selection), or select copy size manually on the touch screen, as required. To Select Copy Size Automatically (APS) APS detects the size of originals placed on the RADF or platen glass and automatically selects and feeds copy paper of the same size, or selects an appropriate size according to the magnification ratio selected. HINTS • See the table on the following page for the relation of original size, magnification ratio and copy paper size. • The initial settings may have been altered by Key Operator. See p. 1310 to p. 13-11. 1. Touch to highlight APS at lower right corner of the Basic Screen. 3 Copying Operations Positioning Originals Setting Print Quantity Set Job During Warmup Stop Scan/Print Copy Size Lens Mode Density 1-1, 2-2 2-1 Multi-Sheet Bypass Tray APS is already highlighted when the initial settings are restored. 2. Select additional copy conditions, as desired. 3. Enter the desired print quantity from the control panel keypad. HINT See p. 3-7 for details on setting print quantity. 4. Position original(s). Using Memory Output without Finisher DF-630/635 Output Modes Binding Mode Recalling Previous Job Check Mode & Proof Copy HINTS • See p. 11-8 to p. 11-10 for copy sizes detectable from the RADF or on the platen glass. • See p. 3-2 to p. 3-6 for details on positioning originals. • Key Operator can deactivate APS when original is set in the RADF or on the platen glass. See p. 13-39 to p. 13-44. Interrupt Mode 3-11