Kyocera KM-8530 KM-8530 Operation Guide - Page 238
on the Application Selection Screen., Position original.
![]() |
View all Kyocera KM-8530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 238 highlights
Repeating Automatically or Selecting Repeating Times (Repeat: AUTO/ Repeat Mode) (continued) 5. Touch OK on the Application Selection Screen. The Basic Screen will be restored. 6. Select the desired magnification and copy size. DETAILS • APS and AMS are automatically released, and 1.00 (100%) is selected as a magnification ratio. • When 2 Repeat, 4 Repeat, or 8 Repeat is selected, the scanning area will be a portion of the selected paper size equally divided according to the selected mode. In this case, magnification ratio will be fixed to 1.00 (100%). • Copy mode is automatically set to 1a1. When selecting 1a2 mode, Platen store mode will function automatically. 7. Enter the desired print quantity from the control panel keypad. HINT See p. 3-7 for details on setting print quantity. 8. Position original. For AUTO mode original, open the document feeder, then position the original FACE DOWN on the platen glass. For 2 Repeat, 4 Repeat or 8 Repeat mode original, RADF is also available. HINT See the illustration on p. 9-36 for details. Reminder! When AUTO mode is selected, Non-Image Area Erase functions automatically. DO NOT close the document feeder. 9. Press [START]. CAUTION When the finisher / trimmer unit / paper exit tray capacity is exceeded due to the print quantity selected, remove the copied sets as they exit; otherwise, mishandled paper will occur. DETAILS The AUTO mode may not operate properly if the lighting in the work place is directly over the platen glass. In this case, consult your service representative about an appropriate place for installation. 9-38
![](/manual_guide/products/kyocera-km8530-km8530-operation-guide-3918ba1/238.png)