LG LSS-3200A Owners Manual - Page 123

SYMPTOMS Aspect Ratio setting is re-set after the channel is changed. SOLUTIONS - When the Format is set to a high-definition setting (720p/1080i) and the incoming program is in high-definition, the Aspect Ratio setting can only be adjusted temporarily. The remote control is not responding. - Make sure the batteries are fresh and installed properly. - Point the remote control unit at the remote control sensor. - Check if the correct function (TV or SAT) on the remote control is selected. - Make sure the correct Remote Control type and code are set for both the remote and receiver. (see section 8-24) The timer does not work. You forget your password. - Make sure the clock is set properly. (see section 8-9) - If you subscribe to satellite service, contact your service provider to arrange for the password to be re-set - If you do not subscribe to satellite service and the DIRECTV HD Receiver is in the ANT/CABLE mode, enter the master password "7777". If a white bar is shown at the top - Use the Component Output. position on the display device - Adjust the scan range of your display device. Audio volume is too low. - If connected to a TV using the "OUT TO TV" jack, set RF mode of "Dolby Digital" menu. (MENU ➝ Audio ➝ Dolby Digital) - Programming sound levels may vary due to broadcast. Dolby Digital broadcasts in general have a much lower volume level than regular broadcasts. Audio dropout or Momentary loss of - Local programming to commercials also sometimes changes the audio audio. format, ie. from dolby 5.1 to 2.0 or L-R. This causes the receiver/amp to have to adjust, and there can be audio drops while the amp recognizes the new format. - Confirm your current channel signal strength (see section 8-21) is stable and strong enough. Poor or fluctuating reception may cause audio dropouts. Conflicting digital channel numbers. - Press the SIGNAL button on the remote control, the physical channel number will be shown. - Press the INFO button on the remote control, the logical channel number will be shown in the channel banner. Cannot tune directly to a station using the remote 10-key. - If you receive more than one station with the same channel number (such as channel 8 from satellite and channel 8 from over-the-air) entering "8" the first time will tune to satellite channel 8, entering "8" a second time will tune to analog channel 8, and so on. Channel content does not match that shown displayed in the GUIDE or INFO banner. - Please confirm that the Dish mode is set to the correct type using Auto Detection for Dish type (see section 8-7) or confirm your dish connections (see section 3-4). 122