Lenovo M5800 Lenovo M5800 Hardware Maintenance Manual - Page 94

Replacing the front audio and USB assembly

Get Lenovo M5800 PDF manuals and user guides View all Lenovo M5800 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 94 highlights

7. Connect one end of the signal cable to the rear of the new hard disk drive and the other end to an available SATA connector on the system board. See "Locating parts on the system board" on page 65. Then, locate an available five-wire power connector and connect it to the rear of the new hard disk drive. Figure 26. Connecting a SATA hard disk drive 8. To complete the installation or replacement, go to "Completing the parts replacement" on page 102. Replacing the front audio and USB assembly Attention: Do not open your computer or attempt any repair before reading and understanding Chapter 1 "Safety information" on page 1. This section provides instructions on how to replace the front audio and USB assembly. To replace the front audio and USB assembly, do the following: 1. Turn off the computer and disconnect all power cords from electrical outlets. 2. Remove the computer cover. See "Removing the computer cover" on page 69. 3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 70. 4. Locate the front audio and USB assembly. 5. Disconnect the front audio and USB assembly cables from the system board. See "Locating parts on the system board" on page 65. Note: Make sure you note the locations of the cables when you disconnect the cables from the system board. 88 Lenovo M5800 Hardware Maintenance Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
7. Connect one end of the signal cable to the rear of the new hard disk drive and the other end to an
available SATA connector on the system board. See “Locating parts on the system board” on page 65.
Then, locate an available five-wire power connector and connect it to the rear of the new hard disk drive.
Figure26. Connecting a SATA hard disk drive
8. To complete the installation or replacement, go to “Completing the parts replacement” on page 102.
Replacing the front audio and USB assembly
Attention:
Do not open your computer or attempt any repair before reading and understanding Chapter 1 “Safety information”
on page 1.
This section provides instructions on how to replace the front audio and USB assembly.
To replace the front audio and USB assembly, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See “Removing the computer cover” on page 69.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 70.
4. Locate the front audio and USB assembly.
5. Disconnect the front audio and USB assembly cables from the system board. See “Locating parts on
the system board” on page 65.
Note:
Make sure you note the locations of the cables when you disconnect the cables from the system
board.
88
Lenovo M5800 Hardware Maintenance Manual