Lenovo ThinkServer RD330 (English) Installation and User Guide - Page 99
Reinstall the riser card assembly 2. The procedure is similar to that of the riser card assembly 1. See
View all Lenovo ThinkServer RD330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
9. Note the orientation of the low-profile bracket and position it on the RAID card. Align the two screw holes in the low-profile bracket with the corresponding screw holes in the RAID card and then install the screws to secure the bracket. Figure 44. Installing the low-profile bracket to the RAID card 10. Position the RAID card near the PCI Express card slot. Ensure that the left edge of the RAID card is inserted into the notch of the RAID card retention bracket 1 . Then, carefully press the RAID card straight into the slot until it is securely seated and the low-profile bracket also is secured by the riser card assembly 2. Figure 45. Installing the RAID card 11. Connect signal cables to the connectors on the new RAID card and the connectors on the hot-swap hard disk drive backplane. See "Mini-SAS to mini-SAS signal cable connections" on page 29. 12. Reinstall the riser card assembly 2. The procedure is similar to that of the riser card assembly 1. See "Replacing the riser card assembly 1" on page 143. What to do next: • To work with another piece of hardware, go to the appropriate section. • To complete the replacement, go to "Completing the parts replacement" on page 147. Then, configure RAID for your server. See "Configuring RAID" on page 56. Chapter 6. Installing, removing, or replacing hardware 87