Lexmark CX431 Users Guide PDF - Page 68

Use printer menus 68 Menu item Description Toner patch sensor setup Calibration frequency preference Disabled Fewest color adjustments Fewer color adjustments Normal* Better color accuracy Best color accuracy Set the default calibration frequency. Toner patch sensor setup Full calibration Run the full color calibration. Toner patch sensor setup Print TPS information page Print a diagnostic page that contains toner patch sensor calibration. Scanner Configuration Scanner Manual Registration Print Quick Test Print a Quick Test target page. Note: Make sure that the margin spacing on the target page is uniform all the way around the target. If it is not, then the printer margins may need to be reset. Scanner Configuration Scanner Manual Registration Front ADF Registration Rear ADF Registration Flatbed Registration Manually register the flatbed and ADF after replacing the ADF, scanner glass, or controller board. Scanner Configuration Edge Erase Flatbed Edge Erase 0-6 (3*) ADF Edge Erase 0-6 (3*) Set the size, in millimeters, of the no‑print area around an ADF or flatbed scan job. Scanner Configuration Disable Scanner Enabled* Disabled ADF Disabled Disable the scanner when it is not working properly. Scanner Configuration Tiff Byte Order CPU Endianness* Little Endian Big Endian Set the byte order of a TIFF‑formatted scan output. Scanner Configuration Exact Tiff Rows Per Strip On* Off Set the RowsPerStrip tag value of a TIFF‑formatted scan output. Note: An asterisk (*) next to a value indicates the factory default setting.