Linksys NSS2000 Cisco NSS2000 Series Network Storage System Getting Started Gu - Page 10

Setting up the Hardware Step 2 - Install the Ethernet Link 2 Step 2 - Install the Ethernet Link After the disk drives are installed in the chassis, you are ready to connect the Ethernet cable. NOTE: If you are hotplugging an Ethernet cable to the NSS after the initial installation, ensure you wait 15 seconds between the time you unplug the cable and plug it back in. Within 10 seconds the newly connected link should appear with the correct IP and link rate in the configuration interface. To connect the Ethernet cable to the NSS: STEP 1 Install the Ethernet cable to the Ethernet port at the back of the NSS chassis. STEP 2 Connect the Ethernet cable to your network. Make sure all the connections are secure. You are now ready to continue with Step 3 - Install the Power. NSS2000 Getting Started Guide 6