Linksys NSS2000 Cisco NSS2000 Series Network Storage System Getting Started Gu - Page 30

LEDs & Buttons Hard Disk Drive LEDs (Front Panel) A Hard Disk Drive LEDs (Front Panel) The ACT and Error LEDs associated with each of the installed disk drives indicate disk-drive activity, or an error condition. The various states of the ACT LED indicates the drive activity: • Solid Green: The disk drive is configured but is currently idle. • Flickering Green: The disk drive is configured, active, and not rebuilding. Flickers off with activity. • Blinking Green: The disk drive is configured and a RAID array is currently rebuilding to the disk drive. • Off: The disk drive is not configured (not part of a RAID or JBOD array and not exported). The various states of the Error LED indicate that the disk drive is in an error condition: • Solid Red: The disk drive is in a failed state. • Blinking Red: The disk drive is predicated to fail (via S.M.A.R.T.). We recommend that you replace the disk drive to avoid the loss of data. • Off: The drive is OK. USB LED (Front Panel) The USB LEDs on the front panel indicate the status of the USB flash drive: • Solid Green: The USB flash drive is connected and is not safe to remove. • Blinking Green: The USB flash drive is connected and is being mounted or unmounted. • Off: There is either no USB flash drive connected to the NSS, or, if connected, the USB hard/flash drive is safe to remove. NSS2000 Getting Started Guide 26