Linksys NSS2000 Cisco NSS2000 Series Network Storage System Getting Started Gu - Page 6
About this Guide, Recommended Installation Sequence, Setting up the Hardware
UPC - 745883577088
View all Linksys NSS2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Introduction About this Guide 1 About this Guide The Getting Started Guide contains the step-by-step details for getting your NSS up and running for the first time---from hooking up the hardware to doing the basic configuration steps to get the NSS running. Users are shown how to log into the NSS to access storage. Recommended Installation Sequence Follow the NSS installation steps to set up and configure the device. They provide out-of-the-box instructions. You can find detailed instructions for each step in the remaining sections of this guide. • Set up the hardware (Chapter 2, "Setting up the Hardware"): - Step 1: Install the disk drives. If your device already has disk drives installed, skip this step. - Step 2: Connect the Ethernet cable. - Step 3: Connect the power. • Configure the NSS (Chapter 3, "Configuring the Network Storage System (NSS)"): - Step 1: Configure the Network Settings IF a DHCP server is not present. (If there is a DHCP server, skip this step.) - Step 2: Log into the Configuration Interface - Step 3: Run the applicable configuration wizards. - Step 4: After you configure the NSS, save a copy of the configuration file to a location on the NSS and to a USB key. • Instruct your users how to access the NSS, if applicable (Chapter 4, "Instructing your End Users" NSS2000 Getting Started Guide 2