Lowrance Elite-12 Ti Installation Manual EN - Page 19
Panel mount, Using an appropriate saw, cut through the template
View all Lowrance Elite-12 Ti manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Panel mount 1. Check the Mounting Template for scaling accuracy, using a tape measure or ruler against the ruler printed on the template. 2. Cut away excess paper, and tape down the template. Check that it is correctly aligned to a vertical or horizontal reference. Do not use a bubble level as the vessel might not be level. Adjust where required. 3. Drill all marked pilot holes. For recommended pilot hole size, refer to the Mounting Template. 4. Using an appropriate saw, cut through the template and mounting surface, along the dotted line bordering the shaded center of the template. 5. Using a fingernail or small flat screwdriver, pry off the corner clips at the slotted points located at the top or bottom of each corner clip. Installation | ELITE Ti Installation Manual 19