Lowrance HDS-5 Gen2 Installation Manual - Page 20
Aligning and Attaching the Transducer
View all Lowrance HDS-5 Gen2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Aligning and Attaching the Transducer Adjust the transducer so that its "face" is parallel with the ground and its center line is even with the bottom of the boat hull. Transducer bracket mounted too low. Transducer bracket mounted too high. Transom Transom Bottom of hull. Bottom of hull. Note: When mounting the transducer to the transom, there are two extremes you should avoid, first, do not let the edge of the mounting bracket extend below the bottom of the hull, left image, above. Second, do not let the bottom of the transducer rise above the bottom of the hull, right image, above. The center line of the transducer should be level with the bottom of the boat hull and its "face" parallel with the ground. Transom Transducer face Do not over tighten the transducer bracket lock nut. If you do, the transducer may not "kick-up" if it strikes an object in the water. Bottom of hull. For single frequency transducers, with a one-piece bracket, assemble it with the cable passing over the bolt and through the bracket, as shown here. 19