Lowrance HDS-5 Gen2 Installation Manual - Page 23
TMB-S Trolling Motor Bracket Installation - trolling motor transducer
View all Lowrance HDS-5 Gen2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
TMB-S Trolling Motor Bracket Installation Note: The TMB-S bracket is designed for one-piece bracket transducers only. The TMB-S trolling motor bracket (Part No. 51-45) is an optional accessory and is available through LEI Extras at www.lei-extras.com. The TMB-S bracket is used to attach a one-piece bracket transducer to a trolling motor. If you regularly fish in water with a lot of underwater structure, such as rocks, stumps and trees, you may consider using a Pod transducer for trolling motor installation. Pod transducers cannot be "kicked up" by underwater structure. Internal tooth washer Bolt Plastic bracket Lock nut Flat washer Using the components supplied with the TMB-S bracket (adjustable strap, internal tooth washer and plastic bracket) attach it to the transducer as shown in the diagram above. Adjustable strap Route the transducer cable along the trolling motor shaft. Use plastic ties (not included) to secure the cable to the shaft. Slide the adjustable strap through the plastic bracket as shown above, left, then slip the strap around the trolling motor as shown in the image, at right. Position the transducer so its "face" is pointing straight down when the trolling motor is in the water. Tighten the adjustable strap securely to the trolling motor. Make sure there is enough slack in the transducer cable for the trolling motor to turn freely. 22