Makita RT0700C Owners Manual - Page 13

For the plunge base (optional accessory) 1 2 1. Screw 2. Base 3. Templet 3 011852 Secure the templet to the workpiece. Place the tool on the templet and move the tool with the templet guide sliding along the side of the templet. 1 7 2 3 4 5 6 1. Bit 2. Base 3. Templet 4. Workpiece 5. Distance (X) 6. Outside diameter of the templet guide 7. Templet guide 003695 NOTE: • The workpiece will be cut a slightly different size from the templet. Allow for the distance (X) between the bit and the outside of the templet guide. The distance (X) can be calculated by using the following equation: Distance (X) = (outside diameter of the templet guide - bit diameter) / 2 Dust nozzle sets For the trimmer base 1 2 1. Dust nozzle 2. Thumb screw 011853 Use the dust nozzle for dust extraction. Install the dust nozzle on the tool base using the thumb screw so that protrusion on the dust nozzle fit to the notch in the tool base. Then connect a vacuum cleaner to the dust nozzle. 011854 MAINTENANCE 1 1. Dust nozzle 2. Thumb screw 3. Trimmer base 011989 3 2 CAUTION: • Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. • Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. 13