Makita RT0700C Owners Manual - Page 9

Offset base (optional accessory) 012085 (1) Offset base (optional accessory) is convenient for work in a tight area such as a corner. 1. Pulley 2. Collet nut 3. Collet cone 011860 Mount the tool on the offset base 1 1. Pulley 2. Belt 2 3 1 2 011858 Before installing the tool on the offset base, remove the collet nut and collet cone by loosening the collet nut. 1. Wrench 2. Pulley 3. Shaft lock 011861 Put an end of the belt over the pulley using a screwdriver and make sure that its entire belt width fits over the pulley completely. 1. Locking lever 2. Offset base 1 1 2 3 011985 Install the pulley on the tool by pressing the shaft lock and firmly tightening the pulley with a wrench. 2 1. Collet nut 2. Collet cone 1 2 011862 Secure it with a locking lever on the offset base. 1. Wrench 1 2. Hex wrench 3. Bit 2 011859 Place the collet cone and screw the collet nut on the offset base as shown in the figure. 3 011992 To install the bit, fall the tool with the offset base on its side. Insert the hex wrench into the hole in the offset base. With the hex wrench held in that position, insert the bit into the collet cone on the shaft of the offset base from the opposite side and tighten the collet nut firmly with a wrench. To remove the bit at replacement, follow the installation procedure in reverse. 9