Makita RT0700C Owners Manual - Page 3

these are connected and properly used. Use of dust collection can reduce dust-related hazards. Power tool use and care 17. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 18. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. 19. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. 20. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. 21. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool's operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. 22. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. 23. Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. Service 24. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. 25. Follow instruction for lubricating and changing accessories. 26. Keep handles dry, clean and free from oil and grease. USE PROPER EXTENSION CORD. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Table 1 shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage number, the heavier the cord. Table 1: Minimum gage for cord Ampere Rating More Than 0 6 10 12 000173 Not More Than 6 10 12 16 Volts 120 V GEB019-4 TRIMMER SAFETY WARNINGS 1. Hold power tool by insulated gripping surfaces, because the cutter may contact its own cord. Cutting a "live" wire may make exposed metal parts of the power tool "live" and shock the operator. 2. Use clamps or another practical way to secure and support the workpiece to a stable platform.Holding the work by your hand or against the body leaves it unstable and may lead to loss of control. 3. Wear hearing protection during extended period of operation. 4. Handle the bits very carefully. Total length of cord in feet 25 ft. 50 ft. 100 ft. 150 ft. AWG 18 16 16 14 18 16 14 12 16 16 14 12 14 12 Not Recommended 5. Check the bit carefully for cracks or damage before operation. Replace cracked or damaged bit immediately. 6. Avoid cutting nails. Inspect for and remove all nails from the workpiece before operation. 7. Hold the tool firmly. 8. Keep hands away from rotating parts. 9. Make sure the bit is not contacting the workpiece before the switch is turned on. 10. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate improperly installed bit. 11. Be careful of the bit rotating direction and the feed direction. 3