Marantz VP8000 VP8000 User Manual - English - Page 13

ENGLISH SET UP PROCEDURES INITIAL SET UP: TO TURN OFF THE POWER 1. Connect the supplied AC power cord. The STANDBY indicator will light in green and the projector goes into the standby mode. 2. Press the POWER ON key on the remote controller or the POWER key on the projector. The POWER key lights in green. 3. Switch on the equipment connected to the projector. Press the INPUT SELECT key on the projector or the COMPONENT key, S-VIDEO key, VIDEO key, or RGB key on the remote controller. 4. Press the OSD key twice on the remote controller to display the FOCUS PATTERN and turn the FOCUS ring to make an adjustment. Adjust the focus for the sharpest image possible to obtain, using the built-in focus pattern. Press the OSD key again to clear the pattern. 5. Turn the ZOOM ring to adjust the size of the image. The image should fill the screen vertically with normal 4:3 aspect ratio material. If the user is using a 16:9 screen, the image will fill the screen horizontally only when the 16:9 source program is employed. The use of 4:3 video source will leave a black stripe on the left and right side in the 16:9 screen. This is normal. 1. Press the STANDBY key on the remote controller or the POWER key on the projector. 2. The fan continues to run for a while to reduce internal heat. The power key flashes green and no key will be functional while the fan is operating. After sufficient cooling has been provided the STANDBY indicator lights in green. 12