Maytag MMMF8030PZ Owners Manual - Page 15

Mark Rear Wall The microwave oven must be installed on a minimum of 1 wall stud, preferably 2, using a minimum of 1 lag screw, preferably 2. See "Find the Wall Stud(s)" section for find the wall studs. 1. Use a pencil to mark the power cord hole and two mounting nut holes. A 3. Hold the cardboard plate on the rear wall while aligning the side center marks (B) on the cardboard plate with the vertical centerline draw in step 1. Make sure the cardboard plate is level, and that the top of the cardboard template is butted up against the bottom edge of the upper cabinet. A B C A. Centerline 2. Align the center markers on the cardboard plate, to the centerline on the wall, making sure it is level, and that the top of the cardboard template is butted up against the back edge of the upper cabinet. (see following NOTE before making marks). Use a pencil to mark the wall venting hole (wall venting installation only), skip it if your unit is for recirculation or upper cabinet venting installation. A. Bottom Edge of Upper Cabinet and Top of the Cardboard Plate B. Side Center Marks on Cardboard Plate C. Centerline 4. Find and mark the two bottom position lines (A) on the cardboard plate. A B A C A. Back Edge of Upper Cabinet B. Wall Venting Hole C. Cardboard Plate NOTE: � If the front edge of the upper cabinet is lower than the back edge, lower the cardboard template so that its top is level with the front edge of the cabinet. D A C B A. Cardboard Plate Bottom Position Line 5. Using the bottom edge of the cardboard plate, align it with the two small lines (A), and draw a line (B) indicating where the bottom edge of the mounting plate (C) should be. A B C A. Rear wall B. Cardboard plate C. Top of cardboard plate must align with front edge of cabinet D. Front edge of upper cabinet A. Two Small Lines B. Cardboard Plate Bottom Line C. Bottom Edge of Mounting Plate 15